Belimo motor Retrofit kit for Ztech Buetler synchron motor 37944L 38572R (Kit 2)

Description

Designed as a direct replacement for Ztech and Buetler damper motors as shown in picture 3, typically Synchron motors   37944L or  38572R Simply remove the long pin synchron or Cramer motor, the spring, and black collar assembly and discard, and them mount the custom shaft adapter to the original damper shaft. Also works on any other Damper with an external shaft, round or Flat,  3/8 inch or under in diameter.  Our ebay store Damper Direct has many other retrofit kits and adapters to get almost any damper back in business-your satisfaction is guaranteed!
This auction is for a Belimo LMB24-3-T Motor and retrofit kit, what is included is the Belimo LMB24-3-T motor, shaft adapter, anti rotation bracket and two self tapping sheet metal screws; anything else in the picture is for illustration purposes.
Tired of replacing spring return damper motors that get hot and burn out? The Belimo to Ztech and Buetler damper retrofit kit  LMB24-Kit2 gets the the premier commercial grade Belimo LMB damper motor and adapter kit.   This kit will also work on virtually any other damper that has a shaft under 3/8 of an inch diameter.
*Retrofits the industry leading LMB24-3-T motor onto Ztech and Buetler dampers recessed into ductboard plenums as shown in pictures.
*Gets rid of spring return motors for better reliability and energy savings.
*Works with any brand of standard 24vac zone control system.
*Saves energy, extends motor life, far more powerful motor with 5 year warranty.
*requires three wires to motor and the mounting of the anti-rotation bracket with two self tapping screws, included.
*24vac 2 va damper motor
Spring return damper motors pull 8 to 10 va of continuous power since they must overcome the return spring. Besides wasting energy, the spring return motors get very hot, contributing to their often premature failure. The Belimo LMB24-3-T retrofit kit motor uses just 2va for  90 seconds, and never even gets warm to the touch! A five year warranty is best in the business, so stop replacing those overpriced spring return motors!
Your current damper has just two wires to the motor, will this 3 wire motor work?  Yes, and for Ztech and Buetler zone control panels, illustrated instructions show you how to add a third wire from the Ztech zone panel to the new Belimo damper motor, and you will be through with energy wasting spring return motors.  You will need a third wire from the zone control panel or thermostat to allow this 3 wire motor to work-very often, standard 4 wire thermostat wire will have been used so check the cable for extra wires. Other brands of zone control panels support three wire motors, including all Honeywell panels, check your zone control board damper outputs for an unused terminal, if your damper outputs are labeled M1,M4, and M6, OR Power Open PO. Power Close PC  and Common C, you have all the outputs you need and are good to go.
Even if your zone panel has just two damper outputs, you can still use this kit since the Belimo LMB motor will accept an alternative wiring procedure that places full time 24vac power on terminals 1 and 2, and then uses the current zone board output for terminal 3.  Full illustrated instructions are included for this hook up on the Ztech zone control panel.
From Damper Direct, where zoning is our only business! We offer the service, support, and technical resources to help you design or service your Zone Control System.
We handle all major brands including Retrozone, Honeywell, EWC, Durozone, Enerzone Systems Corp., Robertshaw, Invensys and more. If you dont see it on ebay, please ask and we can do a special Ebay auction for the part you need.